references
Compact air-air rooftop units
Supervision solutions
Different supervision solutions are available based on the dimensions of the installation for units fitted with Ethernet pCO Web and RS485 Carel / Modbus cards. Management of an humidifier with proportional or on/off control. Energy meter for monitoring of the power consumption of the installation. Energy meter and calculation of the cooling and heating capacities. In addition to the energy meter, the unit incorporates, mixing and supply enthalpic sensors with RS485 communication that enable cooling and heating capacities to be calculated. Refrigerant leak detector. This allows prompt identification of gas leaks, guaranteeing the safety of any people in the vicinity. Installation of the device ensures compliance with European standards F-GAS and EN378 as well as ASHRAE 15.
This is the solution for the management and supervision of a single unit if this incorporates the Ethernet pCO Web card.
• PlantWatchPRO3
This is a solution designed for the monitoring of small and medium-sized installations, capable of managing up to 30 units. Suitable for technical environments, no parts are in movement. It is available in two versions: panel and wall. Includes: 7 “ touch display, buzzer for notifications, 1 USB port and 1 SD card slot for downloading reports, charge devices models and applying service packs. For this option, each unit needs one RS485 Carel / Modbus board.
• PlantVisorPRO2
This is the solution for the management and supervision of air-conditioning installations with up to 300 units. It offers advanced monitoring and maintenance functions and allows zones and groups to be created to simplify the management of the installation. It also allows energy measurements to be integrated to monitor the installations electricity consumption. PlantVisorPRO2 is available in two versions: • Box: comprised of CPU and, optionally, by monitor and keyboard. • Touch: this includes CPU and touchscreen in a single device. For this option, each unit needs one RS485 Carel / Modbus board.
Compressor soft starter. High performance phase monitoring relay, which allows the protection settings to be adjusted (highly recommended for installations with power system voltage instability, lag between current and voltage, high level of electromagnetic disturbances EMC, etc. High performance magnetothermic switches. Tropicalisation: tropicalised components on the electrical cabinet with protective varnish: control board, cards and terminals.
Cross flow models can be attached to standardised pre-assembly roofcurbs with adjustable height, built in galvanised steel panelling with polyester paint and thermal insulation.
These systems are used to manage the installation remotely. All the information on the system can be accessed via a simple internet connection. The online interface, the same one used by the local user, enables monitoring and complete configuration of the installation, from the office or anywhere else the user happens to be. To control multiple sites remotely, there are special tools dedicated to centralised management, such as RemotePRO and RemoteValue.
Regulation system
The levelling system uses angle pieces that allow adjustments in the X and Y axes. Adaptation roofcurbs for replacing units on site are also available for tunnel flow models (upon request).
HEAT PUMPS - AIR CONDITIONNING - REFRIGERATION - AIR HANDLING - HEAT EXCHANGE - NA 17.01 A
505
PJ range
• pCO Web