- Fits perfectly within the suspended ceiling tile dimensions. - White color. - The manual deflectors are adjustable (2 positions) allowing homogeneous air distribution throughout the room.
- Washable filter made of polypropylene with efficiency EU1 regarding EN13779.
Water coil (2-pipe or 4-pipe system)
- Galvanized sheet metal. - Copper tubes, aluminum fins. - Air vent and partial drain. - Nominal pressure: 14bar. - Minimum water inlet temperature : 5 °C. - Maximum water inlet temperature : 70 °C in 2 pipe and 80 °C in 4 pipes.
- Galvanized sheet metal. - Thermal and acoustic insulation of the internal surfaces. - Pre-cut (Ø 70 mm for size 600 and Ø 100 for size 900) Pre-cut Ø 150 mm on the side for air discharge in adjacent room.
- Large ABS electrical box with a hinge to keep it open and screw closure. - Protection rating IP20 - Terminal block on DIN rail in accordance with EN 50022, dept 7.5 mm - Junction block located with tension clamp. Cross section 0.5 to 2.5 mm² - Cable routing for customer connections
Electrical heater (system 2 pipe + electrical)
- Heating element, stainless steel tubes, inserted in the finned block - 2 temperature limiter thermostats (1 auto + 1 manual).
Condensates drain pan
- A condensate drain pan in expanded polystyrene, covered with a waterproof film. - Recovery is provided by a draining pump equipped with a safety float and mounted on anti-vibration mounts. - The auxiliary pan is supplied as a standard accessory to recover the valve condensates.
- Resilents mounts - Valve kit. 2-ways or 3-ways - Valve kit. 2-ways and 3-ways with bypass 230V On/Off - Valve kit. 2-ways and 3-ways 2-ways and 3-ways with bypass 24V 3 pts - Thermostat RTR-E & V30 (AC version only) - Kit V300 & V3000
Fan motor assembly
3-speeds motor. - Closed type, with protected shaft. - Permanent capacitor in the electrical box. - Automatic open thermal protection in series. - Resilient mounts. - Supply 230V-1Ph-50/60 Hz - Reduced consumption.
0 -10V variable speed motor. - BLAC (Brushless Alternating Current) brushless technology offering more linear torque progression and a lower operating sound level than BLDC ( Brushless Direct Current) technology - Sealed, tropicalised with protected shaft - ball bearings - internal automatic overload protection as standard on winding - resilient mounts - Supply 230V-1Ph - 50/60Hz
- Balanced centrifugal impeller with profiled blades. - Polymer impeller.
HEAT PUMPS - AIR CONDITIONING - REFRIGERATION - AIR HANDLING - HEAT EXCHANGE - NA 17.01 A
- Located on the detachable grille, easy to remove without dismantling.