references
Water chillers Heat pump
AQUACIAT LD ILD
AVAILABLE
Options Condenser with anti-corrosion post-treatment Corrosion protection, traditional coils Medium-temperature brine solution Low-temperature brine solution
OPTIONS
Description Copper/aluminium coils supplied with Blygold Polual treatment applied Fins made of pre-treated aluminium (polyurethane and epoxy) Production of chilled water at low temperatures (down to 0°C) with ethylene glycol and propylene glycol. Production of chilled water at low temperatures (down to -15 with ethylene glycol and -12°C with propylene glycol). Unit equipped with special variable speed fans: Xtra Fan (see dedicated section for the maximum available pressure according to the size), with to the duct system. Advantages Improved corrosion resistance, recommended for industrial, rural and marine environments Improved corrosion resistance, recommended for moderate marine and urban environments industrial processes industrial processes Ducted fan discharge, optimised condensing temperature control (or evaporating temperature control on the heat pump version), based on the operating conditions and system characteristics Reduces the noise level by reducing the fan speeds Protects the coils against any impacts Reduces the start-up current Stable operation of the unit when the air temperature is between 0°C and -20°C. Frost protection of the hydraulic module at low outdoor temperatures Frost protection of the water type heat exchanger and hydraulic module down to an outdoor air temperature of -20°C Simultaneous free production of hot water (high temperature) and production of chilled water (or hot water for the heat pump) Optimised operation of two units connected in parallel with run time equalisation no (*) LD ILD no
Xtra Fan Xtra Low Noise Protective grilles Soft Starter Winter operation (down to -20°C) Antifreeze protection down to -20°C
Sound absorbing enclosure for the compressor and low speed fans Metal protective grilles Electronic starter on each compressor Controls the fan speed Electric heater on the hydraulic module
Water heat exchanger and Trace heaters on the water heat exchanger, water pipes, hydraulic hydraulic module frost protection module, expansion vessel and buffer tank module Partial heat recovery Unit equipped with a desuperheater on each refrigerating circuit Unit equipped with an additional water outlet temperature sensor, to be installed on site, enabling Master/Slave operation of 2 units connected in parallel control, pressure transducers. For more details, refer to the dedicated section (expansion tank not included. Option with integrated hydraulic safety components available.) control, pressure sensors. For more details, refer to the dedicated section (expansion tank not included. Option with integrated hydraulic safety components available.) control, pressure sensors. For more details, refer to the dedicated section (expansion tank not included. Option with integrated hydraulic safety components available.) control, pressure sensors. For more details, refer to the dedicated section (expansion tank not included. Option with integrated hydraulic safety components available.) Single high pressure water pump with variable speed drive, water
Master/slave operation
HP single-pump hydraulic module
Quick, easy installation (plug & play)
HP dual-pump hydraulic module
Quick, easy installation (plug & play)
LP single-pump hydraulic module
Quick, easy installation (plug & play)
LP dual-pump hydraulic module
Quick, easy installation (plug & play)
HP single variable-speed pump hydraulic module
reduction in energy consumption for pump use section (expansion tank not included. Option with integrated hydraulic safety components available.) Dual high pressure water pump with variable speed drive, water improved system reliability
HP variable speed dual pump hydraulic module
reduction in energy consumption for pump use section (expansion tank not included. Option with integrated hydraulic safety components available.) improved system reliability