references
Air handling units for swimming pools
AQUAIR PREMIUM BCP
CIATpool electronic control
CIATpool carries out a control of the dehumidification of the pool depending on temperature and humidity of the ambient air probe reading. This control is basically comprised of a μPC MEDIUM control board, a pGD1 graphic terminal, a TCO user terminal (optional) and sensors. A BMS card (optional) allows the connection to a centralised technical management system. It also manages a local connection between units through a pLAN network (μPC MEDIUM Local Area Network), thus allowing communication of data and information for a maximum of 15 units.
pGD1 terminal:
This terminal, installed on the electric panel, allows: The initial programming of the unit and the modification of operating parameters. Unit ON / OFF. The selection of the operating mode and the setting of setpoints. On-screen display of controlled variables and sensor values measured. On-screen display of active alarms and historical record of alarms.
TCO user terminal (optional):
This terminal can be installed on the electric panel, instead of pGD1 terminal. In this case, the remote connection of the pGD1 terminal is posible. Important: with this terminal, it is not possible the access to the parameters.
Options
INERA® coils with copper pipes and fins of an aluminium alloy, of high performance and great resistance to the corrosion. Hot water auxiliary coil of two or four rows, with a proportional three-way valve. Polyurethane coating or fins of INERA® aluminium alloy. This coil has an independent condensates drain pan.
Safety
Differential pressostat for the detection of clogged filters.
Main functions:
Dehumidification control during operating modes: cooling / heating / AUTO Selection of setpoints. Temperature control (with optional hot water coil). Selection of control priorities. Timing of the compressors. Permanent control of the operating parameters. View of the values measured by the probes. Failure diagnosis and main alarm. Water circuit pump control. EC plug-fans control. Air flow control. Cooling recovery circuit control.
Energy meter for monitoring of the power consumption. Transformer for power supply without neutral (on request). Gravimetric filters G4. Gravimetric filters G4 + opacimetric folded filters F6 to F9. Double stage folded opacimetric filters F6 + F8.
Installation
Flexible hydraulic connections for water condenser and hot water coil. Antivibration mounts made of rubber. Hood at the new air intake for outdoor installation. Control with two ambient temperature and humidity probes. TCO user terminal, for installation on the electric panel, instead of pGD1 terminal. Kit remote control to 200 meters with pGD1 terminal (pGD1 terminal + 2 TCONN bypass cards). In this case it´s possible to install the TCO terminal on the electric panel. RS485 serial cards for network communication with protocols: Carel, Modbus, LonWorks®, BACnetTM MSTP, Konnex. Ethernet pCO Web card for network communication with protocols: Modbus TCP/IP, BACnetTM Ethernet, TCP/IP, SNMP V1-2-3, FTP and HTTP.
Optional functions:
Free-dehumidification, free-cooling and regulation of the opening of the of the outdoor dampers. Proportional control of the hot water coil Clogged filter detection. Anti-fire safety. Connection to a centralised technical management system (BMS) for supervision.
490
HEAT PUMPS - AIR CONDITIONING - REFRIGERATION - AIR HANDLING - HEAT EXCHANGE - NA 17.01 A